The XpowerSQUARE Power Factor Correction(PFC) design is uniquely engineered for proven performance for use in commercial building applications. TheXpowerSQUARE is design features include fine-tuning the electrical lines using near exact calculations for determining the ideal capacitance that is needed to optimize inductive loads for improving power factor.

XpowerSQUARE fine tunes the electrical system from the inductive equipment back through the utility company's electric meter. This fine tuning reduces the line noise characteristics for better efficiency.

XpowerSQUARE improve the reactive power while stabilizing the ‘voltage sag’ of a motor. Improving the performance and consistency.

As motors operate, reactive power is "pulled" and "pushed" to and from the XpowerSQUARE by the motor at 60 cycles/second.

The XpowerSQUARE stores and releases what the motors need to function more efficiently. This unique approach serves to reduce the heat generated on the lines, reducing the strain placed on all the electrical components extending their life. Electricity, that would normally be pushed back through the power distribution lines, is reclaimed, stored, recycled, and supplied by the XpowerSQUARE .

The XpowerSQUARE also reduces noise factors that would normally disrupt the operation of motors, causing unacceptable load shifts and overheating, thus shortening the life of equipment and appliances.

XpowerSQUARE Installs Easily In ANY 3-Phase Service Panel
The XpowerSQUARE is easy to install. 
TheXpowerSQUARE requires an independent 3-Pole 20 amp breaker. Installed into a 3-phase 208 volt or 240 volt panel, XpowerSQUARE will not work on 480 volt or 277 volt system.

XpowerSQUARE may be installed outdoors by using an optional NEMA approved weather proof box. (Must be installed by a licensed commercial electrician).

Businesses can now dramatically reduce the cost of determining how much capacitance is required to optimize each inductive load at their facility. The XpowerSQUARE achieves this by eliminating the typical electrical engineering, design, and manufacturing costs for alternative means.
Installation of XpowerSQUARE is fast and simple

The XPS must BE INSTALLED BY A LICENSED COMMERCIAL ELECTRICIAN ONLY.

Only certified distributors can sell the XpowerSQUARE. For more information on the certification, click here.

The Problem? The Department of Energy reports that up to 25% of the billable electricity consumed in businesses is non-productive and unusable. Most AC motors operate at 70 to 80% efficiency under a full load and the efficiency drops dramatically at lower loads. This non-productive energy wastes money and also shortens the life of inductive equipment such as motors, HVAC equipment, pumps and major appliances.

For more information, click here

"Over $16 billion dollars of electricity is unusable energy, but billable in the U.S."
                                                                                   U.S. Dept. of Energy

"The adequacy of North America's electricity system will decline unless changes are made soon ...demand for electricity is expected to increase over the next ten years by 19 percent in the U.S., but confirmed power capacity will increase by only 6 percent."
                              North American Electric Reliability Council (NERC)